Opel Omega

since 1993-1999 release

Repair and operation of the car

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
- 11. Brake system
   11.1. Technical characteristics
   11.2. Brake overlays of forward brakes
   11.3. Brake overlays of back brakes
   11.4. Support of a forward brake
   11.5. Support of a back brake
   11.6. Brake disk
   11.7. Brake shoes of the emergency brake
   11.8. Rope of the emergency brake
   11.9. Lever of the emergency brake
   11:10. Main brake cylinder
   11:11. Tank of brake fluid and sensor of level of liquid
   11:12. Pumping of the brake system
   11:13. Hydraulic tubes and hoses
   11:14. Vacuum hose and valve of the vacuum amplifier of brakes
   11:15. Vacuum amplifier
   11:16. Brake pedal
   11:17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

11.5. Support of a back brake


1. Press the brake hose going to a support.
2. Remove brake slips.
3. Turn off a connection nut.
4. Disconnect a brake tube from a support.
5. Turn off fixing bolts.
6. Remove a support.


1. Clear a support. Remove rings and caps from pistons.
2. By means of compressed air squeeze out pistons. Remove consolidations.
3. Wash out all elements in pure brake fluid and replace the worn-out or damaged elements.


1. Assembly of elements of a support is carried out upside-down.
2. Grease walls of the cylinder, consolidation and pistons with brake fluid before installation. Install pistons so that deepenings on pistons were inclined down at an angle approximately in 23 °.


1. Installation is carried out to the sequences, the return to removal.
2. Tighten fixing bolts of a support till the required inhaling moment.