Opel Omega

since 1993-1999 release

Repair and operation of the car


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
- 11. Brake system
   11.1. Technical characteristics
   11.2. Brake overlays of forward brakes
   11.3. Brake overlays of back brakes
   11.4. Support of a forward brake
   11.5. Support of a back brake
   11.6. Brake disk
   11.7. Brake shoes of the emergency brake
   11.8. Rope of the emergency brake
   11.9. Lever of the emergency brake
   11:10. Main brake cylinder
   11:11. Tank of brake fluid and sensor of level of liquid
   11:12. Pumping of the brake system
   11:13. Hydraulic tubes and hoses
   11:14. Vacuum hose and valve of the vacuum amplifier of brakes
   11:15. Vacuum amplifier
   11:16. Brake pedal
   11:17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



11:15. Vacuum amplifier

Check

PERFORMANCE ORDER
1. Squeeze out a brake pedal several times to remove depression from the vacuum amplifier.
2. Squeeze out a pedal of a brake and start the engine. The pedal has to fall a little.

Removal

PERFORMANCE ORDER
1. Squeeze out a brake pedal several times to remove depression from the vacuum amplifier.
2. Disconnect the connection socket from the sensor of level of brake fluid.
3. Turn off fixing nuts of the main brake cylinder and remove it from the vacuum amplifier.
4. Remove a connecting knee of a vacuum hose.
5. Disconnect a returnable spring from a brake pedal. Remove the switch of fires of a stoplight.
6. Remove a clip and get a pin, the fixing pusher of the vacuum amplifier to a brake pedal.
7. Turn off fixing nuts and remove the vacuum amplifier.

Installation

PERFORMANCE ORDER
1. Twirl a connecting fork on a pusher of the vacuum amplifier so that the distance between a surface of a fixing arm of the amplifier and an opening on a fork was 106,0±0,5 mm. Tighten a lock-nut.
2. Further installation is carried out to the sequences, the return to removal.