Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
- 11. Brake system
   11.1. Technical characteristics
   11.2. Brake overlays of forward brakes
   11.3. Brake overlays of back brakes
   11.4. Support of a forward brake
   11.5. Support of a back brake
   11.6. Brake disk
   11.7. Brake shoes of the emergency brake
   11.8. Rope of the emergency brake
   11.9. Lever of the emergency brake
   11:10. Main brake cylinder
   11:11. Tank of brake fluid and sensor of level of liquid
   11:12. Pumping of the brake system
   11:13. Hydraulic tubes and hoses
   11:14. Vacuum hose and valve of the vacuum amplifier of brakes
   11:15. Vacuum amplifier
   11:16. Brake pedal
   11:17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



11.3. Brake overlays of back brakes

Survey

PERFORMANCE ORDER
Examine brake overlays for existence of wear and measure their thickness by means of a ruler. If any of brake slips demands replacement, it is necessary to replace all four brake slips on both wheels together with antinoise slips.

Removal
PERFORMANCE ORDER
1. Beat out the top fixing pin of antinoise springs.
2. Remove an antinoise spring.
3. Beat out the lower pin.
4. By means of flat-nose pliers or the special tool part brake slips a little in the parties.
5. Remove brake slips.

Installation

Installation is carried out to the sequences, the return to removal.

Check

PERFORMANCE ORDER
1. Lower pistons deep into of a support.
2. Check that cuts on pistons were turned down approximately at an angle in 23 ° in a horizontal.
3. Grease the return surface of slips with high-temperature lubricant.
4. Establish into place fixing pins.