Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
+ 3.1. SOHC engines of 2,0 liters
+ 3.2. DOHC engines of 2,0 liters
- 3.3. 2,5 and 3,0 liters engines
3.3.1. Technical characteristics
3.3.2. Check of a compression
3.3.3. Top Dead Point (TDP) of the N1 piston
3.3.4. Covers of camshafts
3.3.5. Pulley of a bent shaft
3.3.6. Covers of a gas-distributing belt
3.3.7. Gas-distributing belt
3.3.8. Natyazhitel of a belt, asterisks and intermediate pulleys
3.3.9. Epiploons of camshafts
3.3.10. Camshafts and pushers
3.3.11. Head of cylinders
3.3.12. Oil pallet
3.3.13. Oil pump
3.3.14. Oil heater
3.3.15. Flywheel and drive plate
3.3.16. Epiploons of a bent shaft
3.3.17. Fastenings of the engine and transmission
+ 3.4. Partition of all petrol engines
+ 3.5. 2,0 liters diesel engine
+ 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Take off an additional driving belt. |
| 2. Turn a bent shaft so that the tag on a pulley was combined with the index on a cover of a gas-distributing belt. |
| 3. Unscrew the small bolts fixing a pulley to an asterisk of a bent shaft. Remove a pulley. |
|
Installation
| PERFORMANCE ORDER |
| 1. Check whether synchronizing tags are combined. Put on a pulley and tighten bolts. |
| 2. Put on a driving belt. |
|
|
|