Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   - 3.4. Partition of all petrol engines
      3.4.1. Technical characteristics
      3.4.2. Check of a compression
      - 3.4.3. Engine partition
         3.4.3.1. Capital repairs of the engine
         3.4.3.2. Diagnostics of the engine by means of the vacuum gage
         3.4.3.3. Check of a compression in engine cylinders
         3.4.3.4. Capital repairs of the engine - an alternative 3_4_3_5.htm
         3.4.3.6. Block of cylinders of an incomplete complete set
         3.4.3.7. Repair engine (block of cylinders of a full complete set)
      3.4.4. Auxiliary elements of the engine
      + 3.4.5. Engine
      3.4.6. Engine partition
      3.4.7. Head of cylinders and valves
      3.4.8. Pistons and rods
      3.4.9. Bent shaft
      3.4.10. Block of cylinders
      3.4.11. Radical bearings and bearings of rods
      3.4.12. Piston rings
      3.4.13. The first start of the engine after a partition
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


Укрепление фундамента

3.4.3.6. Block of cylinders of an incomplete complete set

GENERAL INFORMATION

The block of cylinders of an incomplete complete set contains the block of cylinders with installed by the krivoshipno-conrod mechanism and piston group. All interfaced details are picked up for dimensional groups, all gaps meet standards. On the block the cam-shafts which are not a part of this remkomplekt, the valvate mechanism, a head of the block of cylinders and hinged units are separately mounted. Costs of machining are minimum or are not required absolutely.