The device, service and repair the Opel Omega - 12.13. Springs of a back suspension bracket//1993-1999 -

Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
- 12. Suspension bracket and steering
   12.1. Technical characteristics
   12.2. Rack of a forward suspension bracket
   12.3. Disorder of forward wheels
   12.4. Lower lever of a forward suspension bracket
   12.5. Spherical hinge of the lower lever of a forward suspension bracket
   12.6. Stabilizer of cross stability of a forward suspension bracket
   12.7. Connecting links of the stabilizer of cross stability
   12.8. Rotary pin
   12.9. Nave and bearings of a forward wheel
   12:10. Cross-piece of a forward suspension bracket
   12:11. Shock-absorber of a back suspension bracket
   12:12. Lever of a back suspension bracket
   12:13. Springs of a back suspension bracket
   12:14. Stabilizer of cross stability of a back suspension bracket
   12:15. Cross drafts of a back suspension bracket
   12:16. System of adjustment of height of a back suspension bracket
   12:17. Back suspension bracket
   12:18. Cross-piece of a back suspension bracket
   12:19. Fastenings of a cross-piece of a back suspension bracket
   12:20. Nave and bearings of a back wheel
   12:21. Steering wheel
   12:22. Steering column
   12:23. Lock of a steering column / lock of ignition
   12:24. Steering mechanism
   12:25. Steering drafts
   12:26. Steering bipod
   12:27. Pump of system of the hydraulic booster of steering
   12:28. Adjustment of wheels and angles of turns
+ 13. Body
+ 14. Body electric equipment



12:13. Springs of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lower a back part of the exhaust system approximately by 300 mm.
2. Disconnect the socket of connection of the sensor of height of a back suspension bracket. Mark position of the lever of the sensor and disconnect it from connecting draft of the stabilizer of cross stability.
3. Disconnect a hydraulic tube from the shock-absorber if it is necessary.
4. Turn off and remove bolts of the lower fastening of the shock-absorber.
5. Disconnect sockets of connection of ABS sensors.
6. Turn off the bolts fixing a damping arm of a cross-piece of a back suspension bracket to a body.
7. Omit the main transfer, a cross-piece of a back suspension bracket and the lever of a suspension bracket and remove a spring and rubber laying.

Installation

Installation is carried out to the sequences, the return to removal.