Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
- 10. Main transfer, half shafts
   10.1. Technical characteristics
   10.2. Main transfer
   10.3. Damping plugs of the main transfer
   10.4. Laying of a back cover of the main transfer
   10.5. Epiploon of the leading gear wheel of the main transfer
   10.6. Epiploons of bearings of half shafts
   10.7. Half shaft
   10.8. Boots of a half shaft and external CV JOINT
   10.9. Driveshaft
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


Профилактика инсульта

10.5. Epiploon of the leading gear wheel of the main transfer

Replacement

PERFORMANCE ORDER
1. Remove the main transfer and clamp it in a vice.
2. Measure a tightness of the bearing of the leading gear wheel. For this purpose put on a key a nut of the leading gear wheel and measure torque at which the leading gear wheel will begin to move. It has to be approximately equal to 90-120 N. to m.
3. Mark the provision of a fixing nut of the leading flange and turn off it, having counted speed. Remove a flange.
4. Replace an epiploon, establish into place a flange and tighten a fixing nut on the counted speed.
5. Adjust a tightness of the bearing of the leading gear wheel, having tightened up a fixing nut of a flange.
6. Establish the main transfer into place.