Opel Omega

since 1993-1999 release

Repair and operation of the car


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
- 10. Main transfer, half shafts
   10.1. Technical characteristics
   10.2. Main transfer
   10.3. Damping plugs of the main transfer
   10.4. Laying of a back cover of the main transfer
   10.5. Epiploon of the leading gear wheel of the main transfer
   10.6. Epiploons of bearings of half shafts
   10.7. Half shaft
   10.8. Boots of a half shaft and external CV JOINT
   10.9. Driveshaft
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


Ford Ka - про автомобиль Ford Ka

10.2. Main transfer

GENERAL INFORMATION

Identification table of the main transfer

1. Differential with sliding restriction (0 – it is established, 1 – it is not established)

2. Transfer relation

The type of the main transfer can be determined by the plate fastening from below a casing of the main transfer.

Removal
PERFORMANCE ORDER
1. Remove both half shafts.
2. Lower pipes of the exhaust system.
3. Disconnect the driveshaft from the main transfer.
4. Establish a support under the main transfer and disconnect sockets of connection of ABS sensors.
5. Turn off fixing bolts and remove the main transfer.

Installation

Installation is carried out to the sequences, the return to removal.

Check of level of oil

PERFORMANCE ORDER
1. Remove a cap (V), turn off a cap (A) and check that oil was at the level of bottom edge of an opening.
2. Add oil if it is necessary, and twirl a cap till the required inhaling moment.

Gulf of oil

Fill in oil of the required type as it is specified in subsection 10.1.