Opel Omega

since 1993-1999 release

Repair and operation of the car

ברכות בר לחתונה וברכות לחינה בסגנונות


Opel Omega
- 1. Maintenance instruction
   + 1.1. Dashboard
   1.2. Opening of the car
   1.3. Rear-view mirrors
   1.4. Switch of an ignition / starter
   1.5. Manual transmission
   1.6. Automatic transmission
   1.7. Start of the engine
   1.8. Release of the emergency brake
   1.9. Parking of the car
   1.10. Multipurpose display
   1.11. Electronic air conditioning system
   1.12. Safety locks
   1.13. Lighting
   1.14. Lubricants and liquids
   1.15. Motive compartment
   - 1.16. Useful tips
      + 1.16.1. Purchase of the car
      1.16.2. Preparation of the car for winter
      - 1.16.3. Councils for owners of the diesel car
         1.16.3.1. What attracts the diesel with?
         1.16.3.2. Why the diesel rustles?
         1.16.3.3. Care of the diesel
         1.16.3.4. Diagnostics of malfunctions (diesels with the fuel Bosch equipment)
         1.16.3.5. Purchase of the second-hand engine
         1.16.3.6. Be healthy, the diesel!
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



1.16.3.3. Care of the diesel

GENERAL INFORMATION

As the diesel pollutes oil in lubricant system quicker, than the petrol engine, most of producers of cars provide more frequent change of oil and the filter.

Special oils of diesels are widely available today and, judging by responses, are quite effective. However any high-quality engine oil for carburetor engines will be suitable also for the diesel if only to change it through certain intervals. Read the label on bank in which the manufacturer usually instructs concerning diesels. If on this label you find nothing, then look at the label on a container in which banks were packed.

At engines with the top cam-shaft it is necessary to replace a gear belt through the specified intervals. Otherwise impact of the piston with valves when the belt suddenly tears is not excluded. Elimination of consequences of the last will involve from you considerable financial costs. In practice there were already cases of break of belts with a run to 48 thousand km, but it resulted from hit on them of oil or water because of depressurization according to lubrication systems and cooling. However, if you take in head to go, without changing a belt, after the run of 58 thousand km, then your unwillingness to spend time for timely replacement of a belt can turn back for you further considerably big expenses of time and money.

For replacement of the fuel filter buy the best of available to you. Some filters can externally look good, but badly "fulfill the direct duties". Do not forget to replace also a sealing ring on the filter case. Still we will note that on the diesel it is equally difficult to prevent both fuel leak, and an air suction in fuel system which strongly break operation of the engine.

If air gets to fuel-supply lines, then removal it from there via the special valve by means of the small manual pump which is usually mounted for these purposes on the fuel pump of high pressure can be required. Many modern diesels have the power supply systems self-deleting air. It is only necessary to krutanut the engine a starter, and air will be removed.

It is difficult to avoid that in the fuel filter moisture therefore for some diesels on the dashboard the alarm lamp informing on availability of water in fuel system is provided was not condensed.

Usually when replacing oil it is required to check a condition of the filter only. However in case of operation of the car under trying conditions, such as the increased humidity and big differences between day and night temperatures, the thicket should check a condition of filters.

All diesels on cold smoke, but it should not be excessive. One of the most common causes of it is failure in the fuel supply moment the pump of high pressure which easily is eliminated by repeated adjustment of the moment of injection on tags on a bent shaft and the pump. This work very much reminds adjustment of an initial corner of an advancing of ignition on the petrol engine. Operation can be performed on the idle engine, however it is better to get for these purposes a special lamp for installation of the moment of injection on the diesel which fastens a clip on a toplivopodvodyashchy tube of a nozzle and breaks out under the influence of pushes of the fuel passing on a tube.

Dribble of fuel through nozzles with leaky closed toplivopodayushchy channel is other reason that can lead to overflow of the cylinder fuel and, as a result, to excessive smoking at start-up. Except the general cleaning of nozzles and replacement about 110 thousand km which are worn out at a run, it is possible to make in house conditions little to check their work. Unless to remove them and to give to check on any control equipment.

New nozzles are not cheap, but you will be able to save the considerable sum, having addressed on the station which is engaged in repair of diesels and to calibrate nozzles at quite reasonable price. The price of service depends on an arrangement of the station and existence of shops of spare parts around it.

However you are able to prolong service life of nozzles, keeping clean the air which is soaked up by the diesel and fuel filters and by that to counteract pollution of nozzles. For these purposes it is necessary to fill in periodically in the fuel tank in a small amount special cleaners.

If to watch the fuel pump of high pressure, then it will function long and regularly. However we want to warn that its replacement – quite expensive invention.

Bad launch and low acceleration performance of the diesel can be caused by many things: substandard starting candles, the contamination of channels of fuel highways leading to fuel supply pressure drop, malfunction of fuel-supply lines and even the wrong installation of nozzles. It is easy to determine badly working starting candles by how the control bulb of prestarting warming up long does not die away.

The provided table of possible defects on the diesel is made by Bosch, and we hope that it will help you to return your engine to working order.

Talk to owners of diesel cars, and you will see that none of them and want to think of again to take the wheel of the petrol car. Perhaps, there came also your turn if the diesel quite answers your inquiries.