Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
- 8. Coupling
8.1. Technical characteristics
8.2. Hydraulic system of the drive of switching off of coupling
8.3. Main cylinder
8.4. Working cylinder
8.5. Coupling pedal
8.6. Clutch plates
8.7. Main malfunctions, their reasons and methods of elimination
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Remove the transmission. |
| 2. Mark the provision of installation of a press disk on a flywheel. |
|
|
3. In a diagonal order gradually turn off fixing bolts and remove press and a frictional disk. Not to damage a diaphragm spring, it is recommended to use the special tool (shooters specified an arrangement of fixing clips of a press disk). |
|
Survey
| PERFORMANCE ORDER |
| 1. Examine a frictional surface on existence of wear, the loosened rivets or pollution. Examine press a disk on existence of deformation, cracks, the broken plates of a diaphragm spring and wear of shliyets. Replace a disk if it is necessary. |
| 2. Examine surfaces of a flywheel and a press disk. If they are strongly scratched or on them there are flutes or cracks, replace them. |
| 3. Check a condition of the release bearing. |
|
Installation
| PERFORMANCE ORDER |
| 1. Wipe press a disk and a flywheel. |
|
2. Establish a frictional disk on a flywheel by springs outside. |
| 3. Establish press a disk and acquire fixing bolts. |
|
4. Establish a frictional disk precisely on the center of a flywheel and casing and gradually in a diagonal order tighten fixing bolts till the required inhaling moment. |
|
|
|