Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   - 3.5. 2,0 liters diesel engine
      3.5.1. Technical characteristics
      3.5.2. Repair operations on the engine installed in the car
      3.5.3. Check of pressure of compression 3_5_4.htm
      3.5.5. Gas distribution mechanism
      3.5.6. Cover of a head of the block of cylinders
      3.5.7. Pulley of a bent shaft
      3.5.8. Chain cover
      3.5.9. Natyazhiteli of a chain
      3.5.10. Chains and asterisks
      3.5.11. Camshafts and pushers
      3.5.12. Head of the block of cylinders
      3.5.13. Oil pallet
      3.5.14. Oil pump
      3.5.15. Oil heater
      3.5.16. Sealing rings of a bent shaft
      3.5.17. Flywheel
      3.5.18. Suspension brackets of the power unit
      + 3.5.19. Capital repairs of the 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



3.5.16. Sealing rings of a bent shaft

RIGHT SEALING RING OF THE BENT SHAFT

Replacement

PERFORMANCE ORDER
1. Remove a pulley of a bent shaft.
2. Using a screw-driver edge as the lever, take a sealing ring from a chain cover.
3. Clear a nest of a sealing ring and the condensed surface of a bent shaft.
4. Grease working edges of a new sealing ring with pure engine oil and, using a tubular mandrel, establish a sealing ring.
5. Remove all traces of oil and establish a pulley of a bent shaft.

LEFT SEALING RING OF THE BENT SHAFT

Replacement

PERFORMANCE ORDER
1. Remove a flywheel.
2. Drill two small openings in an end face of a sealing ring, screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest.
3. Clear a nest of a sealing ring and the condensed surface of a bent shaft.
4. Grease working edges of a new sealing ring with pure engine oil and, using a tubular mandrel, establish a sealing ring into place. Establish a flywheel.