Opel Omega

since 1993-1999 release

Repair and operation of the car

Популярные и чувственные барышни легкого поведения недалеко от метро Дворец Спорта порадуют постоянных господ необычным интимом по доступным тарифам в любое время года. | Шлюхи метро Кировский завод.


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines of 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a bent shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of the camshaft and camshaft
      3.1.11. Pushers and hydraulic elevators
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a bent shaft
      3.1.17. Fastenings of the engine and transmission
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



3.1.8. Natyazhitel of a gas-distributing belt and asterisk

CAMSHAFT ASTERISK

Removal

PERFORMANCE ORDER
1. Take off a gas-distributing belt.
2. Stop a camshaft asterisk.
3. Unscrew a bolt of an asterisk and remove an asterisk.

Installation

PERFORMANCE ORDER
1. Examine an epiploon of the camshaft and, if necessary, replace it.
2. Put on an asterisk the end of the camshaft, совметсив an adjusting pin (1) and an opening in an asterisk (2), and tighten a bolt.

ASTERISK OF THE BENT SHAFT

Removal

PERFORMANCE ORDER
1. Take off a gas-distributing belt.
2. Zastoporte bent shaft.
3. Unscrew a bolt of an asterisk and remove an asterisk. In installation time you need a new bolt.

Installation

PERFORMANCE ORDER
Insert a segment spline into a shaft, put on an asterisk and tighten a bolt.

NATYAZHITEL

Removal

PERFORMANCE ORDER
1. Take off a gas-distributing belt.
2. Unscrew a fixing bolt and remove a natyazhitel.

Installation

Installation is carried out to the sequences, the return to removal.