The device, service and repair the Opel Omega - 3.1.17. Fastenings of the engine and the transmission//1993-1999 -

Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines of 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a bent shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of the camshaft and camshaft
      3.1.11. Pushers and hydraulic elevators
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a bent shaft
      3.1.17. Fastenings of the engine and transmission
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



3.1.17. Fastenings of the engine and transmission

Check

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary replace them.
3. Check that bolts of support were strong tightened.
4. Check whether support are worn-out.

Replacement

LEFT AND RIGHT SUPPORT OF THE ENGINE

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Establish a jack under the engine and the transmission or fix the engine on the elevator.
3. Twist nuts, the fixing support to an arm of the block of cylinders and a body. Remove support. If necessary remove also an arm.
4. Examine support on existence of wear and damages and, if necessary, replace them.
5. Establish support upside-down.

BACK FASTENING OF THE TRANSMISSION

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Establish a jack under the transmission.
3. Unscrew the bolts fixing to a body a cross-piece of a back support of the transmission. Twist the nuts fixing a support to a cross-piece and remove a cross-piece.
4. Unscrew bolts and remove a support.
5. Examine a support on existence of wear and damages and, if necessary, replace it.
6. Establish a support in the return sequence.