Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines of 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a bent shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of the camshaft and camshaft
      3.1.11. Pushers and hydraulic elevators
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a bent shaft
      3.1.17. Fastenings of the engine and transmission
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



3.1.10. Casing of the camshaft and camshaft

Removal

PERFORMANCE ORDER
1. Remove a camshaft casing together with a head of cylinders (see subsection 3.1.12).
2. Remove laying of a casing.
3. Measure a free wheeling of the camshaft, having inserted the measuring probe between a persistent plate and shaft, if necessary replace a persistent plate. Unscrew two bolts of a persistent plate (are specified by shooters in the drawing at the left) and remove a persistent plate (the drawing on the right).
4. Take the camshaft from a casing.

Check

PERFORMANCE ORDER
1. Examine the surfaces of bearings in a camshaft casing on wear existence. If necessary the casing needs to be replaced.
2. Examine necks of bearings and cams of the camshaft. At wear detection, the shaft needs to be replaced. Examine a persistent plate of a shaft and replace it if necessary.

Installation

PERFORMANCE ORDER
1. Establish a new epiploon of the camshaft.
2. Oil the camshaft and install it in a casing. Tighten bolts of a persistent plate and measure a free wheeling of a shaft.
3. Establish a camshaft casing.